B&R 8EI2X2HWT10.0500-1 Servo Drive

B&R 8EI2X2HWT10.0500 - 1 servo drive is a product in the ACOPOS P3 series. The following is a detailed introduction:

Basic information

Supports dynamic node allocation: It has DNA function, which facilitates flexible configuration and management in the system.

Plug-in module slot: There is 1 slot for plug-in modules to achieve functional expansion.

Certification: It has passed CE, UKCA, UL cULus E225616 and other certifications, and the product quality and safety are guaranteed.

Electrical characteristics

Power input

Network configuration: Supports multiple network configurations such as TT, TN, TN - S, TN - C - S, IT, etc.

Voltage range: The main input voltage is 3×200 - 480V AC±10%, and also supports 24 - 120V DC, with a frequency of 50/60Hz±4%.

Apparent power: The maximum apparent power is 7.5kVA, and the maximum inrush current is 45A.

Switching interval: 60s typical.

DC bus

Continuous power: 3kW, reduced proportionally when main input voltage is below 3×400V AC.

Capacitor: DC bus capacitor is 470μF.

24V DC power supply

Voltage: Input voltage 24V DC±25%.

Capacitor: Input capacitor 5500μF.

Current: Current consumption is 1.2A plus motor brake current.

Motor connection

Quantity: 3 motor connection ports.

Power and current: 1kW continuous power, 2.2A RMS continuous current, 6A RMS peak current, and 2.5kW peak power output per motor connection port.

Switching frequency: nominal switching frequency is 5kHz, and selectable switching frequencies are 2.5kHz, 5kHz, 10kHz, and 20kHz. When the switching frequency is 20kHz, the continuous current will decrease at a rate of 0.075A/k starting from 37.1°C; when the installation altitude is above 500m, the continuous current will decrease by 0.22A effective value for every 1000m increase in altitude.

Features

Fieldbus: Powerlink v2 controlled node (CN), 2 RJ45 interfaces, shielded, 2-port hub, maximum segment length of 100m, transmission rate of 100Mbit/s.

Enable input: There are 2 enable inputs, current-sinking circuits, electrically isolated from ACOPOS P3 and inputs, nominal input voltage 24V DC, maximum 30V DC, input current at nominal voltage is about 9mA.

Encoder interface: 3 digital multi-encoder interfaces, configurable, 8-pin female Mini I/O connector, no status indicator, no electrical isolation between encoder and ACOPOS P3, maximum encoder cable length 75m.

In addition, the servo drive also has a variety of protection functions, including overload protection, short circuit and ground fault protection, to ensure the safe and stable operation of equipment and systems.